The PinLED display set 10101 is suitable for all pinballs from Williams and Data East with 2x16 digit alphanumeric displays.

You can adjust the display with DIP-switches to work either in Williams or in Data East pinballs.

Fits the following pinballs:

Installations guide for the PinLED Display-Set 10101
Before you begin with the installation of the PinLED Display-Set please check the contents of your packaging.
1. The new PinLED Display
2. Four spacers
3. This installation guide
You don’t need any tools for the installation. If you have further questions – please let us know…. support@pinled.de. Then you get help as soon as possible.
If you follow the next steps the installation is very easy and safe.

1. Unplug the mains plug.
2. Open the Backbox. Store the Backglass in a safe place.
3. Put the Display/Speaker Panel on the playfield cover glass.
4. Disconnect the cables from the original displays.
5. Remove the four screws of the old display. You will need them later to mount the new display.
6. Remove the old display.
7. Set the DIP switches to work either in Williams or Data East pinballs.
8. Get the new PinLED Displays into a suitable position.
9. Take the four spacers which are included in the PinLED Display-Set into a suitable position.
10. Mount the new display with the four screws.
11. Connect the cables from the system 11 board to the new display. It is not possible to mix them up! The red wire on the flat cable is then on the left of the new PinLED Display board (Pin 1) and on the system 11 board to the right (Pin 1).
12. Remove the high voltage fuses on the power supply board. There are one or two fuses depending on you board! This is only to be on the safe side. The new PinLED Displays will also work with installed fuses. But the high voltage isn't longer in use after the conversion to PinLED Displays.
13. Install the Back glass again.
14. Connect the mains plug.
15. That's it! Switch on the pinball and enjoy playing in new dimensions.....